Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
Assembly
1.Match up holes in Plug (27) to pins in Cord Connection (6), plug in, and secure with Cord Retainer (26).
2.Place Sponge in the bottom of the handle rest unit.
3.Set up handle rest unit within easy reach of the Soldering Station.
4.Plug Soldering Station into any standard, Sponge
120V AC electrical outlet.
Functions
The Digital Soldering Station is designed to heat
solder in order to secure wiring and metal surfaces together.
Handle Rest (when cold)
Solder
Work
Area
Handle Rest (when hot)
Operating Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Tool set up
1.Check for breakage, worn parts, damaged cords, or any other condition that may effect the tool’s operation. If damaged, have the tool serviced by a qualified tech- nician before using.
2.Tighten the Tip Retainer (16) on the Soldering Iron (15).
3.Select the correct solder for the intended application. Read the directions for the solder being used to determine what temperature level to set on the Soldering
Station. To minimize the risk of damage to surrounding components, select the minimum heat required to melt the solder chosen for the application.
4.Plug Soldering Station in and turn Power Switch (4) to the “ON” position. Turn the Temperature Dial (8) and wait until the desired temperature is displayed on the LCD Display (5) or push one of the Preset Buttons.
•Preset Button 1 = 150ºC (302ºF)
•Preset Button 2 = 270ºC (518ºF)
•Preset Button 3 = 360ºC (680ºF)
SKU 96531 | For technical questions, please call | Page 10 |
