4.To remove the Drill Bit, pull back on the Spring (41) and pull out the Bit. For optimal performance, always keep Drill Bits and Chisels sharp. NOTE: When drilling a hole larger than
Drill Bit with four cutting edges.
(See Figure A.)
General Operating Instructions
1.Before plugging in the Power Cord
(112), insert the desired Bit. Adjust the Auxiliary Handle (107) and Depth Gauge (106) to the desired positions.
Then adjust the Switching Knob
(24)and Selector (91) to the desired positions. (See Figure A.)
2.Make sure the Power Switch (96) is in its “OFF” position. Then plug the Power Cord (112) into the nearest
110 volt, grounded, electrical outlet.
(See Figure A.)
3.When ready to use the Rotary Hammer, squeeze the Power Switch
(96)and allow the tool to run without load for about one minute. This allows the tool’s parts to become properly lubricated. Check to see if the running tool sounds normal. Once the tool has been warmed up, it is ready for use. (See Figure A.)
4.When finished using the Rotary
Hammer, release the Power Switch
(96).Wait until the tool comes to a complete stop. Then unplug the tool from its electrical outlet. (See Figure
A.)
5.Make sure the Drill Bit is completely cooled. Then remove the Bit from the tool.
6.Store the Rotary Hammer in its Carrying Case (105) and keep the Case in a clean, dry, safe location out of children’s reach.
SKU 97743 | For technical questions, please call | Page 12 |
