Tool Set Up
Adjusting The Auxiliary Handle:
1.The Auxiliary Handle (107) can be placed in a variety of positions.
(See Figure A.)
2.To rotate the Auxiliary Handle (107), turn the Auxiliary Handle counterclockwise to loosen the band and Foursquare Bolt (111). Once loosened, turn the Auxiliary Handle to the desired position. Then turn the Handle clockwise to secure in place.
(See Figure A.)
Using The Depth Gauge:
1.The Depth Gauge (106) can only be used if the Auxiliary Handle (107) is positioned on either side or the top of the Rotary Hammer. The body of the Hammer will interfere with the Depth Gauge if the Handle is in the bottom position. (See Figure A.)
2.Loosen the Auxiliary Handle (107) by turning the Handle counterclockwise.
(See Figure A.)
3.Once the Auxiliary Handle (107) is sufficiently loose, pull back on the
Handle Holder (108) until the hole in the Handle is fully open.
(See Figure A.)
4.Slide the Depth Gauge (106) in to the desired length. The tip of the Depth Gauge on the front of the Hammer should be the desired depth of the hole to be drilled. The depth is from the tip of the Drill Bit to the tip of the Depth Gauge.
•For example; for a 2” deep hole, measure 2” back from the tip of the Drill Bit. Then position the front tip
of the Depth Gauge at that spot.
(See Figure A.)
5.After the Depth Gauge (106) is placed in the desired position, turn the Auxiliary Handle (107) clockwise until tight. The Depth Gauge should be securely in position and should not move. (See Figure A.)
Changing The Settings:
1.The Rotary Hammer has a Switching Knob (24) and a Selector (91) which must be adjusted before drilling, hammer drilling, or chiseling.
(See Figure A.)
2.WARNING! Move the Switching Knob (24) and Selector (91) only when the Motor is stopped. Attempting to move the Switching Knob or Selector while the Motor is engaged will result in abrupt Bit rotation and can cause serious personal injury and/or property damage.
(See Figure A.)
3.CAUTION: When moving the Switching Knob (24) and Main Handle (91), make sure both actively “click” into the desired position. If not actively engaged, the Knob or Handle could slip out of position resulting in unexpected tool performance.
(See Figure A.)
4.The front Switching Knob (24) has on one side a symbol of a Hammer and a Drill. On the other side is a symbol of just a Hammer. (See Figure A.)
5.The Main Handle (91) can be pointed either left or right. There are symbols for a Hammer and a Drill on the left
SKU 97743 | For technical questions, please call | Page 10 |
