Maintenance And
Servicing
Procedures not specifically explained in this manual must be performed only by a qualified technician.
To prevent serious injury
from accidental operation:
Turn the Power Switch of the tool to its “OFF” position and unplug the tool from its electrical outlet before performing any inspection or maintenance.
To prevent serious injury from tool failure:
Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected before further use.
Cleaning, Maintenance, and
Lubrication
1.BEFORE EACH USE, inspect the general condition of the tool. Check for loose screws, misalignment or binding of moving parts, cracked or broken parts, damaged electrical wir- ing, and any other condition that may affect its safe operation.
2.After Use, When using latex paint, clean the sprayer and components with clean water. When using oil based paint, use mineral spirits to clean the sprayer and components.
a. Lock the Gun and remove the Spray Tip assembly.
b. Submerge the Suction Tube in a container with the appropriate clean- ing solution.
c. Place the waste material container next to the paint container.
d. Aim the Spray Gun into the paint container and pull the trigger.
e. Turn the Power switch to the “ON” position and the “PRIME/SPRAY” knob to “SPRAY”. Purge the paint into the original container until the cleaning solution starts coming out.
f.Move the Spray Gun to the waste container and continue holding the
Trigger down until the cleaning fluid coming out is
g.Release the Trigger, turn the “PRIME/SPRAY” knob to “PRIME” and pull the trigger once to release pressure.
h.Turn the power switch of the unit “OFF” and lock the Gun.
i.Remove the Suction Hose and re- turn tube and clean them.
j.Wipe the thread of the inlet nut and remove and clean the inlet filter.
k.Thread the suction tube back in place and reconnect the return tube onto the return tube fitting.
l.Submerge the suction set in a con- tainer of NEW cleaning solution.
m.Turn the “PRIME/SPRAY” knob to “PRIME” and squeeze the trigger once into the waste container to relieve pressure.
n. Allow the pump to circulate the cleaning solution through the suction set for three minutes. If oil based paints were used, the unit must
SKU 99702 | For technical questions, please call | Page 14 |
