SpecificationsAssembly
Electrical Requirements | 120 V~ / 60 Hz / | |
7.5 A | ||
| ||
Motor | 3/4 HP | |
Operating PSI | 2350 – 2650 psi | |
Paint Flow | 0.33 GPM | |
Fuse | Class F, F10A/250 V | |
Hose Size | 1/4” | |
Oil Requirement | Hydraulic Oil |
Unpacking
When unpacking, make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
Instructions for putting into use
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
To prevent serious injury
from accidental operation:
Turn the Power Switch of the tool to its “OFF” position and unplug the tool from its electrical outlet before assembling or making any adjustments to the tool.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
1.Turn the knobs on the handle coun- terclockwise, pull the handle up, and secure it by turning the knobs clock- wise. Repeat with lower knobs to raise the Sprayer to the correct height for the job. The Sprayer should be 1/4” above the bottom of the pail.
Knobs
2.Insert the ends of the hose bracket into the holes on the inside of the handle.
3.Remove the hex nuts on the front of the unit, then use them to secure the pail bracket to the unit.
Pail Bracket
PRIME/SPRAY
Knob
REV 08j
SKU 99702 | For technical questions, please call | Page 9 |
