Installing the Seat Pad, Installation in Aircraft | Chicco Car Seat

INSTALLATION IN AIRCRAFT

This Child Restraint is certified for use in commercial aircraft. Be sure to contact your airline prior to travel, to discuss their Child Restraint policy.

CLEANING & MAINTENANCE

Fabrics may be spot-cleaned with mild soap and water, or machine washed in cold water on delicate cycle using mild detergent. Hang to dry. DO NOT USE BLEACH.

1Position Carrier rear facing in aircraft seat, with child properly secured in Carrier.

2Route Aircraft Lap Belt under both Belt Guides, and fasten the aircraft belt.

3Tighten Aircraft Lap Belt while pushing Carrier firmly into aircraft seat.

A tightly rolled airline blanket may be used under the front edge of the Carrier if needed for stable, secure installation.

4Check Installation:

aLevel Line on Carrier MUST be LEVEL with ground.

bAircraft belt MUST be TIGHT.

cCarrier MUST be STABLE and secure.

2

3 4

b

a

Removing the Seat Pad Remove Harness Straps from Harness Slots as described in “Changing Harness Height.”

1Unhook elastic band attached around handle pivots, and disconnect chest clip and buckle.

2Carefully pull seat pad from under Adjuster Cover. ADJUSTER COVER MUST REMAIN IN PLACE. Guide harness assembly through slots in bottom of seat pad, while removing from Carrier.

Installing the Seat Pad

Reverse the removal instructions to reinstall the Seat Pad.

Carefully follow instructions in “Changing Harness Height” to ensure the harness is properly routed and adjusted.

1

2

NEVER use Carrier without the Seat Pad.

38

39

Image 20

Chicco Car Seat manual Installing the Seat Pad, Installation in Aircraft, Cleaning & Maintenance

Contents

Page Table of Contents Registration & Recall Safe USE ChecklistEnsure Child is in Size Range TakeTime to ReadThis User Guide Install Restraint Correctly Never install in rear facing or side facing vehicle seats Check Condition of Restraint Base Features Storage CompartmentBase Overview Bubble is between arrows Removing Latch Storing LatchPull Latch Pull Strap to Firmly slide shoulder belt Carrier Overview Chest Clip Harness Adjuster To loosen harness, firmly pressHarness Buckle To Install Insert in Carrier To extend/retract visor To release carrier from base Carrier out of baseHead Support CARRIER/BASE Attachment Pounds 2 and 5 kg Child RequirementsOnly use this child restraint Make sure child is properly secured Securing Child in Carrier Safety Tips for Securing Child Secure Child ChecklistProperly secured and tightened Harness around your child Check Position of Chest Clip Results in Secure Installation of Restraint Unsafe Vehicle BeltsNon-Locking ELR Lap Belts Best Position is one that Check Installation Belts Must be Tight Uninstalling BaseBubble Must be Between arrows Carrier to Base Check Installation Latch belts Must be Installation Using LatchInto vehicle seat Not interfere with Attachment of Carrier To Base Check Installation Installation Using Latch Installation Without BaseVehicle belt Must be Tight Secure Cleaning & Maintenance Installing the Seat PadInstallation in Aircraft Cleaning Buckle Latch Hardware Cleaning PlasticsCleaning Harness Latch Straps