INSTALLATION USING LATCH
LATCH or Vehicle Belt? This Child Restraint can be safely installed using Vehicle Belts or LATCH. Use the method that results in the MOST SECURE installation in your vehicle.
INSTALLATION USING LATCH
5 Tighten LATCH Belts by | 5 |
pulling up firmly on LATCH Pull |
|
Strap while pressing Base firmly |
|
into vehicle seat. |
|
1Remove LATCH Connectors from storage pockets while lifting up on LATCH Release Lever.
2Position Base in forward facing vehicle seat with Recline Foot against seat back.
3Adjust Base Angle by pushing Recline Buttons while lifting Base. Angle is correct when Bubble is between arrows.
Vehicle must be on a level surface for the Bubble to indicate correctly.
4Attach LATCH Connectors by pushing them firmly onto vehicle LATCH Anchor Bars. Verify connection is secure by pulling firmly on LATCH straps.
1
2
3
4
CLICK!
6 | Store LATCH Pull Strap neatly | 6 | ||
in Pull Strap Storage Pocket. | ||||
| ||||
7 Check Installation |
| |||
| a LATCH belts MUST be |
| ||
|
| TIGHT |
| |
| b Base MUST be STABLE | 7 | ||
| c Bubble MUST be |
| ||
|
| between arrows |
| |
| d LATCH Pull Strap MUST |
| ||
|
| NOT interfere with |
| |
|
| attachment of Carrier |
| |
|
| to Base. |
| |
8 | Attach Carrier to Base after |
| ||
properly securing child in Carrier. |
| |||
|
| ALWAYS lift up on Carrier |
| |
|
|
| ||
| to verify it is properly attached | 8 | ||
| to the Base. |
| ||
This child restraint base is designed to be used with lower LATCH anchors at the standard spacing (11 inches) ONLY! Refer to vehicle owner’s manual for information about LATCH and child restraint installation positions.
34 | 35 |
