Installation Instructions |
DISPLAY SECURITY SCREWS
Select the appropriate hardware from the security kit to secure your display. Select the procedure, listed below, that applies to your application.
Flush Mount (no spacers required)
Recessed Mount (spacers required)
Flush Mount
1.Verify that you have the correct parts.
2.Remove two M4 x 12mm screws from the top mounting holes on the display.
3.Install two M4 x 12mm security screws (60) into the top mounting holes on the display (see Figure 2).
4.Repeat Steps 2 and 3 to install the two remaining M4 x 12mm security screws (60) into the bottom mounting holes on the display.
Recessed Mount
1. Verify that you have the correct parts.
NOTE: If your display uses a screw size other than M4 x 20mm, DO NOT use the M4 x 20mm security screws. Using the wrong screws could result in damage to your display.
2.Remove two M4 x 20mm screws from the top mounting holes on the display, exercising care to retain the two spacers beneath the Centris mount.
3.Install two M4 x 20mm security screws (70) and two spacers into the top mounting holes on the display (see Figure 2).
4.Repeat Steps 2 and 3 to install the two remaining M4 x 20mm security screws (70) into the bottom mounting holes on the display.
M4 x 12mm Security Screw (typical)
Centris
Mount 
Display
Figure 2. Flushed Mount
M4 x 20mm Security Screw (typical)
Centris
Mount
Spacers
Display
Figure 3. Recessed Mount
4
