Chief Manufacturing FSA-1004, KSA-1004 Adjusting Lateral Movement, Adjusting Lift Arm Tension

Installation Instructions FSA/KSA-1004

Adjusting Lateral Movement

CAUTION: Over-tightening tension bolt will cause excessive wear and may distort adjustment components.

To adjust the lateral movement tension, perform the following procedures:

1.Slightly tighten or loosen the tension adjustment bolt.

2.Check for desired tension. Repeat as necessary.

Adjusting Lift Arm Tension

CAUTION: Over-tightening tension bolt will cause excessive wear and may distort adjustment components.

To adjust the tension of the lift arm:

1.Raise or lower the lift arm until tension adjustment bolt appears in the opening.

2.Using the 5/32” hex key (provided), adjust the tension adjustment bolt, as follows:

NOTE: There is no fixed number of revolutions to turn the tension adjustment bolt. Tighten or loosen the bolt, as needed. When the bolt is adjusted correctly, the display can be easily raised or lowered at any time, and stay in place without sagging.

a.To increase lift arm tension, turn the tension adjustment bolt counterclockwise.

b.To decrease lift arm tension, turn the tension adjustment bolt clockwise.

3.Raise or lower the lift arm to check for desired tension. Repeat step 2 as needed.

Lateral

Tension Adjustment Bolts (Typical)

Adjusting Lateral Movement

Lift Arm Tension

Adjustment Bolt

Adjusting Lift Arm Tension

6