Chief Manufacturing KSA-1020 Wall Mounting Using Steel Studs or Drywall, Side View

KSA-1020 Installation Instructions

Wall Mounting Using Steel Studs or Drywall

After determining the site meets the installation requirements:

1.Identify desired mounting location on wall.

2.Using a stud finder or similar method locate stud.

3.Align mounting holes in mount with stud making sure mounting holes are centered on stud. (See Figure 9)

WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT!

4.Mark location of two mounting holes on wall using the wall plate as a template. Mark holes where the top and bottom holes of the bracket will be connected. (See Figure 9)

5.Drill two 1/2" holes. (See Figure 9)

4 5

1/2"x21/2"(

Mounting holes centered on stud

Figure 9

6.Hold metal channel on anchor (B) flat alongside plastic straps and slide channel through hole. (See Figure 10)

Drywall
Plastic Straps	6
(B) x 2

Figure 10

7.Holding plastic straps on anchor (B), pull anchor away from wall until channel rests flush behind wall making sure anchor channel is positioned vertically on stud. (See Figure 11)

8.Slide plastic cap on anchor (B) towards wall until flange of cap is flush with wall. (See Figure 11)

Steel Stud
Drywall
Plastic Cap
8	7
(B) x 2
Anchor Metal Channel
(Side View)

Figure 11

9.Snap off plastic straps on anchor at wall by pushing side to side, snapping off straps level with flange of plastic cap. (See Figure 12)

10.Repeat steps 6 through 9 for remaining mounting hole.

	Steel Stud
	Drywall
9	Plastic Cap
Plastic Straps
	Anchor Metal Channel
	(SIDE VIEW)

Figure 12

11.Place mounting bracket over anchors and align mounting holes in display mount with holes in anchors. (See Figure 13)

12.Insert 1/4-20 x 1-3/4" Phillips pan head screw (E) into mounting hole on mounting bracket and into anchor (B) and tighten until flush against mounting bracket. DO NOT overtighten! (See Figure 13)

13.Repeat steps 11 through 13 for remaining mounting hole.

8