Installation Instructions | KSG110 |
Centris Cup |
|
7 | G2 or G3 |
| (4 places) |
| G4 or G5 |
5 | (4 places) |
Figure 6
Cable Management
1.Attach all cables to display.
2.Open the cable management bracket by sliding it towards the edge of the arm (See Figure 7).
NOTE: If necessary, cable management bracket attach screws may be loosened using hex key.
| Attach |
| Screws |
OPEN Position | CLOSED Position |
View from Bottom | |
Figure 7
CAUTION: Ensure that adequate cable slack exists for movement of display, and that cables will not be pinched when bracket is closed.
3.Carefully insert cables into bracket (See Figure 8).
Cable Management
Bracket (in open position)
Cable Path (typical) 
NOTE: Display not shown for clarity.
Figure 8
4.Close cable management bracket by sliding it back towards the centerline of the arm (See Figure 7).
NOTE: If necessary, cable management bracket attach screws may be tightened using hex key.
CAUTION: Ensure that adequate cable slack exists for movement of display, and that cables will not be pinched by installation of cover (E) or screws (F).
5.Carefully insert cables in cavity located in lower portion of mount arm (See Figure 9).
6.Using Phillips screwdriver, install cover (E) with two screws (F).
Cable Path |
(typical) |
E |
F x 2 |
Figure 9
Installation is complete.
Adjustments
Centris Head Tension Adjustment
1.If previously attached, disconnect cables from display, remove display.
7
