3.As shown in Figure I, now tighten the 4 Socket Head Screws (65) to secure the guard bracket in place.
4.To adjust the height of the
Blade Guard Assembly (50), loosen the Hex Screws (68). Raise the Guard Assembly
to the desired height. Then retighten the two Hex Screws.
See Figure J.
5. | After making any adjustments to or installing the Blade |
Figure J | Guard Assembly (50), make sure that the Guard is |
| aligned properly and doesn’t contact the Blade. |
To Attach The Fence Assembly:
1.CAUTION! Prior to installing the Fence Assembly (75), make sure the Table Saw is disconnected from its electrical power source.
2.To attach Fence Assembly (75) to the Table (105), raise the Fence Handle (80) to a horizontal position. Slip the Front Board (94) of the fence over the front edge of the Table. (See
Figure K)
3.Slip the rear Clamp (89) of the Fence Assembly onto the top/rear edge of the Table, lowering the Fence Assembly all the way onto the Table (105).
Then, lock the Fence Assembly in position by
lowering the Fence Handle to a vertical position. Figure K (See Figure L)
Tension
Adjustment
Screw
BLADE GUARD ASSY. (50) | FENCE ASSY. (75) |
|
Fence Handle (80)
(UNLOCKED POSITION)
FIGURE L
SKU 45804 | PAGE 13 |
