move the left hand safely away from the workpiece and the Saw Blade (3). Then, continue pushing the workpiece into the Saw Blade, with the Push Stick, until the cut is complete. (See Figure O.)
7.Once the cut is complete, continue to maintain control of the workpiece. Turn the Power Switch (179) to its OFF position. Then, wait until the Saw Blade (3) completely stops rotating before removing the workpiece.
NOTE:
TOP VIEW OF TABLE
BLADE GUARD ASSY. (50)
SAW BLADE (3)
WORKPIECE CUT LINE
FENCE ASSY. (75)
PUSH Stick (37) | FIGURE O |
|
TABLE SAW OVERLOAD PROTECTION
1.The Table Saw is equipped with a Circuit Breaker (178). If the motor shuts off or fails to start due to overloading (cutting stock too fast, using a dull Saw Blade (3), low voltage, using the Table Saw beyond its capacity, etc.), turn the Power Switch (179) to its OFF position. Let the motor cool three to five minutes, and push the Circuit Breaker button which will reset the overload device. The motor can then be turned on again in the usual
manner. (See Figure P.) | Figure P |
INSPECTION, MAINTENANCE, AND CLEANING
1.WARNING! Always disconnect the Table Saw from its electrical pow- er supply source before performing any inspection, maintenance, or cleaning procedure.
2.Before each use, inspect the general condition of the Table Saw. Inspect switch, power plug and cord assembly, and extension cord (if used) for damage. Check for loose screws, misalignment, binding of moving parts, broken, cracked, or improper mounting of the Saw Blade (3), broken parts and any other condition that may affect its safe operation. If abnormal noise or vibration occurs, turn off the Table Saw immediately and have the problem corrected before further use.
Do not use damaged equipment.
SKU 45804 | PAGE 16 |
