Installation Instructions | MFC, PFC Series |
Attaching Display to Cart
WARNING: EXCEEDING MAXIMUM WEIGHT CAPACITY MAY LEAD TO SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! It is the installer’s responsibility to ensure the total amount of weight placed on the cart does not exceed 125 lbs (56.70 kg) for the MFC, and 200 lbs (90.72 kg) for the PFC.
CAUTION: Before attaching display to cart set the brakes on the back wheels by pressing down on the tab.
(See Figure 5)
Press down to set brakes
Figure 5
1.Adjust the cart to the desired height by holding the top part of the post, pulling out knob on the center post and turning 90o in either direction to disengage the locking mechanism.
2.Raise or lower the center post, then turn the knob 90o either direction to engage the knob and lock the cart at desired height. (See Figure 6)
Do NOT let |
display rest |
here |
2 |
1 |
5 |
Figure 7
WARNING: DISPLAY MAY WEIGH IN EXCESS OF 40 LBS! Always use two people and proper lifting techniques when installing or positioning display on cart.
5.Lower display into place listening for audible "click" to ensure recessed area of mounting buttons are properly seated in lower area of mounting holes. (See Figures 7 & 8)
WARNING: IMPROPER INSTALLATION CAN LEAD TO CART OR DISPLAY FALLING CAUSING SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! Ensure mounting buttons are completely engaged in mounting holes.
NOTE: Holes are provided in the faceplate for use with a padlock or similar locking device, if desired. In addition, the pin and nut may be removed from the upper holes and moved to the lower holes for use as a more permanent locking device. (See Figure 8).
Figure 6
IMPORTANT ! : Set the height of the cart so the display does NOT rest on the lower part of the center post. (See Figure 6.) Always set the height so the knob is engaged in a hole in the center post.
3. | Attach a PSBU or MSBU interface bracket to the display |
| following the instructions included with the bracket. |
4. | While supporting both sides of display, align four mounting |
| buttons on display or interface bracket with four mounting |
May remove pin and nut and move to lower holes
4
5
A padlock or bolt may be placed through latch holes
holes in head assembly. (See Figures 7 and 8) |
Figure 8
7