Chief Manufacturing MFC Series Tilting Display, Cart Use and Maintenance, Cable Management

MFC, PFC Series Installation Instructions

Tilting Display

The display can be tilted up to 15o either backward or forward from a straight upright position.

1.Turn knob counterclockwise on back of head assembly to loosen the tilt. (See Figure 9)

1	3
		lock display
		Place optional bolt
	4	(not provided) here
		to lock in an upright
		position.
		(MFC Shown)

Figure 9

2.Tilt display as desired, to a maximum of 15o either forward or backward.

3.Turn knob clockwise to tighten display on head assembly. (See Figure 9)

CAUTION: Tighten knob on back of head assembly to prevent damage when moving the cart and display.

4.If leaving the display in a straight upright position, it is recommended that a bolt (not provided) be placed through the head assembly (see Figure 9) to lock the display into the upright position.

	2	(Rear
(Front view		view of
of center post)		center post)
1	3
Exits for
signal cables
Snap-on
covers		Exit for
		power
		cables

Figure 10

Cart Use and Maintenance

CAUTION: This cart is intended for use only with the products and maximum weights indicated (125 lbs [56.70 kg] for the MFC, and 200 lbs [90.72 kg] for the PFC). Use with other products or products heavier than the maximum weights indicated may result in instability causing possible injury.

Cable Management

1.Signal cables can be run down the front flap of the center post and out the front of the post at any of the openings. (See Figure 10)

2.The display power cord can be run through the top and down through the post to exit out the back. (See Figure 10)

3.Any accessory power cords can be run through the front and down through the post to exit out the back. (See Figure 10)

4.Install the snap-on covers to any opening that is not being used. (See Figure 10)

5.To remove the snap-on covers, grip the sides of the cover in the middle and pull off. They can also be removed by inserting a flat-blade screwdriver into the bottom slot and rotating the screwdriver.

WARNING: CART CAN TIP OVER RESULTING IN RISK OF INJURY. Do not allow children under 16 to move cart. Only adults should move this cart. Move cart slowly. Apply moving force on narrow dimension. Never apply force at top - always push near middle. Push, don’t pull.

8