Chief Manufacturing PFC Series, MFC Series installation instructions Removing Display from Cart

Installation Instructions MFC, PFC Series

Do NOT push

cart near top

Push cart near

middle

Figure 11

1.Always place cart on level surface.

2.Always lock the wheels when the cart is not moving.

3.Check and tighten the hex nuts on the casters occasionally. (See Figure 12) These should be checked especially after use on uneven ground.

x 4

Figure 12

Removing Display from Cart

1.Remove bolt or padlock from faceplate (if used). (See Figure 13)

NOTE: The pin may have been used as a more permanent locking device. If so, remove nut and pin and move from the lower holes to the upper holes.

2.Pull back on flag on upper mounting hole and press pin down into "Open" position. (See Figure 13)

WARNING: EACH DISPLAY MAY WEIGH IN EXCESS OF 40 LBS! Always use two people and proper lifting techniques when installing or positioning display on stand.

3.Carefully lift display from cart.

4.Lift up on pin and place flag back against faceplate to return it to "Closed" position. (See Figure 13)

1	Remove bolt
	or padlock	2
	if used
Pin in
"Closed"
position -
move to
"Open"
position to
remove
display
	4
Pin in
"Open"
position -
move to
"Closed"
position
after display
is removed.

Figure 13

9