Installation Instructions | MSR Series |
ATTACH MSB TO THE DISPLAY
To attach the MSB to the display, do the following:
To help your identify the correct MSB that matches the model number of your display, refer to the cross- reference chart at www.chiefmfg.com.
To download the corresponding MSB installation instructions, refer to www.chiefmfg.com.
OR
Contact Customer Service at
INSTALL THE DISPLAY
IMPORTANT! Display size may impact the ability to effectively reach the latching flag. If this is the case install the optional “Latching Flag Extension kit” provided with mount and reinstall display. See “Latching Flag Extension Installation” below.
To install the display, do the following:
NOTE: Verify that all power/audio/video cables are disconnected and MSR latching flag is in the “down” position before attempting to mount the display.
1.With the aid of another person, lift the display up to the mount (10) on the wall, aligning mounting buttons with the teardrop slots on the mount, and lower the display firmly into place (see Figure 6).
2.Raise latching flag to secure the display (see Figure 7). If the flag does not fully engage, check to ensure the mounting buttons are fully seated in the slots.
NOTE: A padlock may be installed through the hole in the latching flag for additional security.
REMOVE THE DISPLAY
To remove the display from the mount, do the following:
1.Disconnect all power/audio/video cables.
2.Lower the latching flag to unlock the display.
3.With the aid of another person, lift the display up and out of the teardrop slots in the mount to remove the display.
Display
MSR Mount
MSB
Figure 6. Install the Display
Lock
Teardrop Slot
Unlock
Latching Flag
Figure 7. Raise Latching Flag to Lock
6
