PAC501 | Installation Instructions |
INSTALLATION
WARNING: IMPROPER INSTALLATION CAN RESULT IN DEATH OR SERIOUS PERSONAL INJURY! This accessory should be installed by qualified personnel.
Site Preparation
Locate and Prepare Mounting Site
1.Identify a suitable wall location for the
IMPORTANT ! : The
WARNING: ELECTRICAL SHOCK HAZARD! CUTTING OR DRILLING INTO ELECTRICAL WIRES OR CABLES CAN CAUSE DEATH OR SERIOUS PERSONAL INJURY! ALWAYS make certain area behind mounting surfaces is free of electrical wires and cables before cutting, drilling, or installing fasteners.
WARNING: EXPLOSION AND FIRE HAZARD! CUTTING OR DRILLING INTO GAS PLUMBING CAN CAUSE DEATH OR SERIOUS PERSONAL INJURY! ALWAYS make certain area behind mounting surfaces is free of gas, water, waste, or any other plumbing before cutting, drilling, or installing fasteners.
2.Using a stud sensor, locate and mark studs.
3.Center and level housing between marked studs.
4.Using housing as a template, draw pencil line completely around housing. (See Figure 1)
5.Cut drywall on outside edge of line and remove.
Wood Studs |
(A) |
Figure 1
Frame Housing
The exposed portion of the center wood stud must be removed and the resulting cavity completely framed with wood. The following steps are suggested. The actual procedure is dependent upon the specific installation.
WARNING: STRUCTURAL FAILURE HAZARD! FAILURE TO TAKE ADEQUATE PRECAUTIONS CAN LEAD TO DEATH OR SERIOUS INJURY! Ensure removal of center stud will not cause unacceptable loss of structural strength. Consult a qualified building contractor and applicable building codes.
1.Remove exposed portion of center wood stud flush with upper and lower drywall edges.
Support |
Blocks |
Horizontal Framing |
Top View |
Wood |
Screws |
(5 places) |
(Typical for each |
support block) |
Figure 2
6