Model: | Installation Instructions |
|
|
INSTALL MOUNT TO WALL
1.Determine approximate mounting location, keeping in mind the display size.
WARNING: The mount must be installed on two or three wood studs (or other equivalent vertical or horizontal supporting framework). Do not mount to single wood studs. Failure to properly install unit can result in serious personal injury or damage to equipment!
2.Use a stud sensor to locate applicable wood studs. Mark locations with a pencil.
3.Level mount at desired height per one of the configurations below:
NOTE: Either configuration below provides ± 2" of lateral shift.
•16" on center studs: The mount is approximately centered between two or three studs as shown (See Figure 8).
•24" on center studs: The mount is offset to the left or right of center between two studs as shown (See Figure 9).
Centered between 2 studs |
|
Lag Bolt & |
|
Washer |
|
(8 Places) |
|
| Lag Bolt & |
Centered between 3 studs | Washer |
(8 Places) |
Figure 8: 16" On Center Stud Installation
Left of center installation |
|
Lag Bolt & Washer |
|
(8 Places) |
|
| Lag Bolt & |
| Washer |
Right of center installation | (8 Places) |
|
Figure 9: 24" On Center Installation
4.Using mount as a template, mark the location of the pilot holes. Ensure the following:
•Marks are in the center of wood studs.
•8 pilot holes are marked (one in each slot).
NOTE: For 16" on center, 3 stud installation: Lag bolts and washers on center stud are optional.
5.Drill pilot holes using a 7/32" drill bit. Ensure pilot holes are straight.
6.Using 1/2" wrench, install eight 5/16" x 2 ½" lag bolts and eight 5/16" washers through mounting holes and into pilot holes. Tighten all lag bolts.
NOTE: Lag bolts and washers are not supplied.
6
