Installation Instructions | PST 2000 Series |
ATTACH PSB TO THE DISPLAY
To attach the PSB to the display, do the following:
To help your identify the correct PSB that matches the model number of your display, refer to the
To download the corresponding PSB installation instructions, refer to www.chiefmfg.com.
INSTALL THE DISPLAY
To install the display, do the following:
NOTE: Verify that all power/audio/video cables are disconnected from the display and the latching flag is lowered in the down position before attempting to mount the display.
1.With the aid of another person, lift the display up to the mount (10) on the wall, aligning mounting buttons on the PSB with the teardrop slots on the mount, and lower the display firmly into place (Figure 8).
2.Raise the latching flag (2 places) to secure the display (see Figure 9). If the flag does not fully engage, check to ensure the mounting buttons are fully seated in the slots.
NOTE: A padlock may be installed through the hole in the latching flag for additional security.
REMOVE THE DISPLAY
To remove the display from the mount, do the following:
1.Disconnect all power/audio/video cables.
2.Lower the latching flag to unlock the display (see Figure 10).
3.With the aid of another person, lift the display up and out of the teardrop slots in the mount to remove the display.
To install display, align the mounting buttons on the PSB with teardrop slots on the mount.
Figure 8. Mount Plasma Static Bracket to Wall
Raise latching flag to lock display
Figure 9. Raise Latching Flag to Lock
Lower
latching 
flag to
unlock display
Figure 10. Lower Latching Flag to Unlock
6
