Installation Instructions | Model: |
INSTALLATION
Pole Mount
WARNING: THE STRUCTURAL MEMBER MUST BE CAPABLE OF SUPPORTING 4 TIMES THE COMBINED WEIGHT OF ALL COMPONENTS PLUS THE EQUIPMENT BEING MOUNTED.
1.Verify truss plate (10) is properly oriented for installation.
10 | Recessed, Slotted Flat Surface |
| Against Pole |
Slot at bottom |
|
Figure 2: Truss Plate Orientation for Pole Installation
2.Attach truss plate (10) to pole using Chief accessory clamps or equivalent. (See Figure 3)
NOTE: Contact Chief Customer Service at
3.Adjust truss plate (10) vertical and horizontal position until desired location is obtained. (See Figure 4)
4.Secure truss plate to pole by tightening clamp hardware. (See Figure 4)
Clamp |
10 |
Figure 3: Install Back Plate to Pole
Tighten Clamp Hardware |
(4 places) |
10 |
Figure 4: Position and Secure Back Plate
Truss Mount
WARNING: THE STRUCTURAL MEMBER MUST BE CAPABLE OF SUPPORTING 4 TIMES THE COMBINED WEIGHT OF ALL COMPONENTS PLUS THE EQUIPMENT BEING MOUNTED.
1.Verify truss plate (10) is properly oriented for installation.
NOTE: The orientation of the truss plate when mounted on a truss is the same as when mounted on a pole. (See Figure 2)
2.Locate mount location on truss.
3.Attach truss plate (10) to truss using Chief accessory clamps or equivalent. (See Figure 3)
NOTE: Refer to page 2 of this document for available Chief mounting clamp kits. See Available Mounting Clamp Kits on page
4.Adjust truss plate (10) vertical position until desired location is obtained. (See Figure 4)
5.Secure truss plate to truss by tightening clamp hardware. (see Figure 5)
3
