XSM/XTM Series | Installation Instructions |
Center of bracket |
Figure 4
WARNING: IMPROPER INSTALLATION CAN LEAD TO DISPLAY FALLING CAUSING SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! Using screws of improper size may damage your display. Properly sized screws will easily and completely thread into display mounting holes. If spacers are required, be sure to use longer screws of the same diameter.
2.Select correct screws, spacers (if necessary) and washers from the hardware bag and attach brackets to back of screen. (See Figure 4)
Switching Interface Brackets (Optional)
If an installation situation makes adjusting the location of interface brackets necessary, there are several options.
1.The wall brackets may be adjusted side to side at the point of attachment. (See Figure 5)
2.The location of the left and right interface brackets may be switched, with the knobs on the XTM interface brackets facing the inside of the mount. (See Figure 5)
1
Knobs
2
Figure 5
3.If necessary, the tilt interface bracket knobs may be switched to allow the interface brackets to be reversed. (See Figure 6)
a.Remove display from mount.
b.Remove interface brackets from display.
c.Hold the right interface bracket horizontally, tightly gripping it so that spacers do not move.
d.Remove the knob, washer and screw.
e.Replace the knob, washer and screw in the opposite order, with the knob on the inside of the bracket.
f.Switch the right interface bracket to the left side of the wall mount.
g.Repeat Steps 3c through 3f with the left interface bracket.
8
