CONNECTING PROJECTOR
TERMINALS OF PROJECTOR
This projector applies various input/output terminals and 3 terminal slots for expansion to tune to diversity of signals from computers and video equipment.
NOTE; DVI Terminal is unavailable for INPUT 3 slot.
2 TERMINAL SLOTS (Factory set)
INPUT/OUTPUT TERMINALS
|
| DVI |
|
| AUDIO | CONTROL PORT | |
|
|
|
| R | L | ||
|
|
|
|
| |||
|
|
|
|
|
| (MONO) | |
R/Pr | G/Y | B/Pb | H/HV | V |
| AUDIO | CONTROL PORT |
R |
| L | |||||
|
|
|
|
|
| ||
(MONO)
| AUDIO OUT | |
SERIAL PORT IN | SERIAL PORT OUT | USB |
R/C JACK | R | L |
|
| |
RESET |
| (MONO) |
INPUT 3 INPUT 2 INPUT 1
DVI Terminal
5 BNC Terminal
REPLACEMENT OF TERMINAL
NOTE; When replacement of terminal board, MAIN ON/OFF switch should be OFF position.
1 | Remove 2 Screws on terminal. |
2 | Pull out terminal by holding handle. |
3 | Replace terminal. Insert terminal along Guide to fit Plug |
into Socket. | |
4 | Tighten screws to secure terminal. |
NOTES ON ORDERING OR USING OPTIONAL INTERFACE BOARD
Screws
Guide
Socket
When ordering or using Optional Interface Board (Terminal Board), contact your sales dealer. When con- tacting the sales dealer, tell the Optional Control Number (Op.cont.No.) in the menu that is located under Language Select Menu. (See page 39.)
Plug
Figure shows HDB 15-PIN terminal (Optional parts).
11
