Christie Digital Systems 38-VIV403-01 user manual Connecting Projector, Terminals of Projector

CONNECTING PROJECTOR

TERMINALS OF PROJECTOR

This projector applies various input/output terminals and 4 terminal slots for expansion to tune to diversity of signals from computers and video equipment. 4-built-in Terminal Slots enable you to arrange desired combinations of input sources just by changing Terminal Boards. For Terminal Boards, contact sales dealer where you purchased a projector.

4 TERMINAL SLOTS (Factory set)

	SERIAL PORT IN			DVI			AUDIO	L	CONTROL PORT
							R
							(MONO)
	SERIAL PORT OUT		R/Pr	G/Y B/Pb H/HV		V	AUDIO		CONTROL PORT
							R	L
							(MONO)
	R/C JACK	USB	VIDEO/Y	C	S-VIDEO		AUDIO
							R	L
INPUT/OUTPUT							(MONO)
	AUDIO OUT						AUDIO		CONTROL PORT
TERMINALS	R	L		ANALOG RGB			R	L
		RESET
		(MONO)					(MONO)

INPUT 4 INPUT 3 INPUT 2 INPUT 1

DVI Terminal

5 BNC Terminal

AV Terminal

HDB 15-PIN Terminal

REPLACEMENT OF TERMINAL

NOTE; When replacement of terminal board, MAIN ON/OFF switch should be OFF position.

1	Remove 2 Screws on terminal.
2	Pull out terminal by holding handle.
3	Replace terminal. Insert terminal along Guide to fit Plug
	into Socket.
4	Tighten screws to secure terminal.

NOTES ON ORDERING OR USING OPTIONAL INTERFACE BOARD

When ordering or using Optional Interface Board (Terminal Board), contact your sales dealer. When con- tacting the sales dealer, tell the Optional Control Number (Op.cont.No.) in the menu that is located under Language Select Menu. (See page 40.)

Screws

Guide

Socket

Figure shows HDB 15-PIN terminal.

Plug

11