BASIC OPERATION
TURNING ON / OFF PROJECTOR
TURNING ON PROJECTOR
1 | Complete peripheral connections (with Computer, VCR, etc.) |
before turning on projector. (Refer to "CONNECTING TO | |
| PROJECTOR" on pages 12~14 for connecting that equipment.) |
2 | Connect a projector's AC Power Cord into an AC outlet. LAMP |
Indicator lights RED, and READY Indicator lights GREEN. | |
| NOTE : When “On start” function is ON, this projector is turned |
| on automatically by connecting AC Power Cord to an |
| AC outlet. (Refer to page 39.) |
3 | Press POWER |
Control Unit to ON. LAMP Indicator dims, and Cooling Fans |
start to operate. Preparation Display appears on a screen and
Current Input position and Lamp mode status are also displayed on screen for 5 seconds. (Refer to "LAMP MODE" on page 37.)
Input position and
Lamp mode status
30
Preparation Display disappears after 30 seconds.
| TURNING OFF PROJECTOR | |
1 | Press POWER |
|
Control Unit, and a message "Power off?" appears on a screen. |
| |
2 | Press POWER |
|
Indicator lights bright and READY Indicator turns off. After |
| |
| projector is turned off, Cooling Fans operate (for 90 seconds). | Message disappears after 4 seconds. |
| During this "Cooling Down" period, projector cannot be turned | |
|
| |
| on. |
|
3 | When projector has cooled down, READY Indicator lights |
|
GREEN again and you can turn projector on. After cooling down |
| |
completely, disconnect AC Power Cord.
TO MAINTAIN LIFE OF LAMP, ONCE YOU TURN
PROJECTOR ON, WAIT AT LEAST 5 MINUTES BEFORE
TURNING IT OFF.
When “Power Management” function mode is Ready or Shut down, projector detects signal interruption and turns off the Projection Lamp automatically. Refer to “Power management” on page 39.
When WARNING TEMP. Indicator is flashing, projector cannot be turned on, refer to the section "MAINTENANCE" on page 42. When the both WARNING TEMP. and READY Indicator flashing, refer to the section "MAINTENANCE" on page 42.
20
