WIRING
1.Wire all heaters and controls in accordance with the appropri- ate wiring diagram provided below.
2.Run a ground jumper from the ground screw in one terminal box to the ground screw in the adjacent terminal box. (See Figure 4.)
3.Do a final and complete check of all wiring then replace the terminal box covers being careful not to pinch any wires.
4.The front panel may now be installed.
5.Place the front panel over the flange of the bottom panel. Hook the top back edge of the front panel over the top panel, and secure with screws.
Table 2: Terminal Box Volumes (Cubic Inches)
Heater Style | Left Hand Box | Right Hand Box |
| 4” Wide | 5” Wide |
146.25 | 182.75 | |
|
|
|
WARNING: TO PREVENT THE RISK OF FIRE, DO NOT OPERATE THE HEATER WITHOUT THE FRONT PANEL IN PLACE.
WIRING DIAGRAMS
Limited Warranty:
Please refer to the Chromalox limited warranty applicable to this product at
2150 N. RULON WHITE BLVD., OGDEN, UT 84404
Phone: | www.chromalox.com |