Cisco Systems 10005 manual

Download 20 pages, 844.44 Kb

Success! {{ $ctrl.successMessage }}

Errors!

1 2

Corporate Headquarters: Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA

78-12652-01

Cisco 10005 ESR AC Power Supply Installation

March 30, 2001

This installation note provides procedures for installing and replacing AC power

supply modules in a Cisco 10005 edge services router (ESR).

The following sections are included in this installation note:

•Product Description, page 2

•Prerequisites and Preparation, page 2

•Adding or Replacing an AC Power Supply, page7

•FCC Class B Compliance, page 13

•Related Documentation, page14

•Obtaining Documentation, page15

•Obtaining Technical Assistance, page17

Search

Models

10005

Cisco 10005 ESR AC Power Supply Installation
- Contents
- 2Product Description
- Prerequisites and Preparation
  - 3Safety Guidelines
    - Safety Warnings
  - 6Required Tools and Equipment
- 7Adding or Replacing an AC Power Supply
  - Installing a Second AC Power Supply
    - 78-12652-01
    - Figure2 Installing an AC Power Supply
      - FAULT
      - POWER
    - Step 5 Connect the AC power cord to the new power supply.
    - 8Captive screws
      - Cisco 10005 ESR AC Power Supply Installation
  - 10Replacing an AC Power Supply
    - FAULT
    - POWER
    - Warning
    - Never install an AC power module and a DC power module in the same chassis.
    - Follow these steps to replace an AC power supply:
      - Step 1 Put on an antistatic wrist or ankle strap. Attach the strap to the ESD grounding
    - jack on the front of the chassis or to the bare metal surface of the chassis.
      - Step 2 If your system is configured with redundant power supplies, set only the power
    - switch of the power supply you are replacing to the standby position (Figure4).
      - Caution Do not power off both AC power supplies in a redundant system, or the system
    - shuts down and all data traffic stops. Power off only the ACpower supply you are replacing.
      - Figure4 Setting AC Power Switch to the Standby Position
    - 11the chassis using the handle on the faceplate.
      - FAULT
      - POWER
      - Step 7 Connect the power cord to the new power supply.
      - Step 5 Before you install the new power supply, make sure that its power switch is set to
    - the standby position (see Figure4).
      - Step 6 Insert the new AC power supply all the way into the power bay to ensure a secure
    - connection to the midplane (Figure 5). Tighten the captive screws on the power supply.
      - Figure5 Installing an AC Power Supply
      - Captive screws
  - Troubleshooting the Installation
- 13FCC Class B Compliance
- 14Related Documentation
- 15Obtaining Documentation
  - World Wide Web
  - 16Documentation CD-ROM
  - Ordering Documentation
  - Documentation Feedback
- 17Obtaining Technical Assistance
  - Cisco.com
  - Technical Assistance Center
    - 18Contacting TAC by Using the Cisco TAC Website
    - Contacting TAC by Telephone
      - 20Obtaining Technical Assistance

Contents