Chapter1 Product Overview
System Modules
1-18
Cisco Metro 1500 Series Hardware Installation Guide
78-10588-03
Data Rate Transparent Front Panel LEDs
The WCM LEDs provide information about its operating status. Table1-3
describes the LEDs.
WCMs with Fixed Clock Recovery
The following transparent WCMs are available with fixed clock recovery:
High-speed transparent WCM that supports data rates of 622 Mbps
High-speed transparent WCM with 1062-Mbps clock for coupling link
WCM that supports 2.488 Gbps
WCM with 850-nm multiclock
Note WCMs with settable clock recovery are also available. See the
“WCMs with Settable Clock Recovery” section on page 1-20.
Table1-3 Transparent WCM LED Descriptions
Label Color1
1. Any other state than the ones listed indicates a possible failure in the local system.
Description
On/Err Green Power is on. No software or hardware errors are detected.
Red A hardware or software error was detected or the
initialization is in progress (during system startup only).
Red
blinking WCM is in manual setting mode (not shown in case of
error).
Loop Orange A remote and/or a local loop is established.
L/R Green Data is received from the local port.
L/T Green Data is transmitted to the local port.
R/R Green Data is received from the remote end of the link.
R/T Green Data is transmitted to the remote end of the link.
Green
blinking WCM is in ALS mode; LED blinks once every 10 seconds.