| can see poor | Carrier Extension is |
| |
| network | detailed in subsection |
| |
| connections or | 35.2.3.5 in the IEEE |
| |
| excessive numbers | 802.3 specification. |
| |
| of dropped packets. | Carrier Extension can |
| |
| The interoperability | be used to pad the last |
| |
| issue arises when a | byte of a packet, so |
| |
| module with a ten | the packet is aligned |
| |
| bit interface (TBI) | on an even−numbered |
| |
| transmits an odd | boundary. |
| |
| byte packet to a |
|
| |
| receiver with a |
|
| |
| Gigabit |
|
| |
| media−independent |
|
| |
| interface (GMII). |
|
| |
|
|
|
| |
Sun Microsystems | Unable to manually | Manually setting | Contact vendor technical | |
QFE Card | speed and duplex | support to obtain the | ||
set speed and | ||||
| only affects the first | latest driver to resolve | ||
| duplex correctly. | |||
| of four ports. | the issue. | ||
|
| |||
|
|
|
| |
Sun Microsystems |
| V1.1 can potentially | Contact vendor technical | |
v1.1 Gigabit Cards | Unable to establish | |||
not establish link to | support or v2.0 Gigabit | |||
| link. | |||
| switch. | Card. | ||
|
| |||
|
| Full−duplex operation |
| |
|
| is only supported at |
| |
|
| 10 Mbps. Full−duplex |
| |
|
| is not supported at |
| |
|
| 100 Mbps. The |
| |
|
| LineMode keyword |
| |
|
| has no effect on |
| |
|
| performance at 100 |
| |
Xircom CreditCard |
| Mbps. If the |
| |
Ethernet 10/100 | Not negotiating or | LineSpeed keyword |
| |
CE3B−100 | operating correctly | is set to 100 Mbps |
| |
| at 100 Mbps, | and the LineMode |
| |
| full−duplex. | keyword is set to |
| |
|
| full−duplex, the |
| |
|
| LineMode keyword is |
| |
|
| ignored. Full−duplex |
| |
|
| at 10 Mbps is only |
| |
|
| available when the | Do not operate this NIC | |
|
| adapter is connected | ||
|
| at 100 Mbps, | ||
|
| to a | ||
|
| full−duplex. | ||
|
| full−duplex−capable | ||
|
|
| ||
|
| switch or hub. |
| |
|
|
|
| |
Xircom CreditCard | Not negotiating 10 | The CE3 and, in some | On these adapters, in | |
Ethernet 10/100 | Mbps full−duplex. | cases, the CE3B are | order to operate in | |
CE3B−100 |
| not capable of | full−duplex mode, the | |
|
| negotiating to 10 | LineSpeed keyword must | |
|
| Mbps, full−duplex | be set to 10 Mbps, and | |
|
| mode. | the LineMode keyword | |
|
|
| must be set to | |
|
|
| full−duplex. The cable | |
|
|
|
|