Basic LS2020 Configuration Tasks
•Method 2, changing modem baud rate through use of redundant
Method 1
If you have access to the local console, perform the following procedure to match the modem port baud rate:
Step 1 Issue the set command from the console:
set {sa sb} modem baudrate {2400 9600}
where {sa sb} represents either Release 2 switch card A or B, as appropriate, and {2400 9600} represents the available choices in matching the modem port baud rate.
Step 2 Issue the init command at the TCS hub prompt:
init {sa sb} modem
This command initializes the modem port on the specified switch card with the selected baud rate.
Method 2
If you do not have access to the local console, but you can dial into the LS2020 chassis by means of a switch card, perform the following procedure to match the baud rate of the desired modem port:
Step 1 Dial in to the LS2020 chassis and determine the address of the switch card to which the desired modem is attached, that is, the modem for which you are attempting to match the baud rate.
Step 2 Issue the set command at the TCS hub prompt:
set {sa sb} modem baudrate {2400 9600}
In this command, specify the switch card having the
Step 3 Issue the init command at the TCS hub prompt:
init {sa sb} modem
Again, as in Step 2 above, specify the switch card having the
Attaching a Terminal and Matching the Baud Rate
Figure
To attach the terminal cable to the console port and to match the terminal and the console port baud rates, perform the following procedure:
Step 1 Connect the cable for the
Hardware Installation