Cisco Systems 2020 manual Fantail Installation Procedure, H3691

Installing Fantails

Figure 2-4 Fantail Cable Connections

V.35 fantail

Front view

Rear view

RS-449 fantail

Rear view

Front view

Low-speed access card

H3691

100-pin high-density connectors support four ports each

Fantail Installation Procedure

To install fantails in your LS2020 switch, perform the following steps:

Note Before installing fantails, check the interface jumpers on each low-speed access card. These jumpers must be set to the interface displayed on the fantail(s) for that card. For instructions on setting interface jumpers, see the LightStream 2020 Hardware Reference & Troubleshooting Guide.

Step 1 Select a position on the rack to mount the fantail. Attach the four clip nuts provided with the fantail to the appropriate holes in the rails.

Step 2 Put on the ESD wrist strap and connect it to the ESD jack on the rear of the LS2020 chassis.

Hardware Installation 2-9