Basic LS2020 Configuration Tasks
Configure the Chassis Secondary IP address (for use by a network processor while acting as backup). This address should be an address on the subnetwork connecting all network processors in your network.
Chassis Secondary IP Address [a.b.c.d]: 192.1.1.12
Your system may be attached to an external Ethernet LAN by means of the
In a redundant configuration with two network processors, if the network processors are each attached to an external Ethernet LAN by means of the
If the network processors are attached to an Ethernet LAN, you will be asked to provide the IP address and IP subnet mask of the network processors'
Are the two network processors attached to an Ethernet LAN (Y/N)? [N] Y
In a redundant configuration with two network processors, the primary (active) network processor provides the logical connection to the attached Ethernet LAN. Thus you will be asked to specify only one IP address and mask.
Configure the IP address for the network processors' Ethernet LAN interface.
Network Processor Ethernet IP Address [a.b.c.d]: 197.112.23.12
Configure the IP subnet mask for the network processors' Ethernet LAN interface.
Network Processor Ethernet IP Mask [a.b.c.d]: 255.255.255.0
Is there an IP router on the attached Ethernet LAN (Y/N)? [N] Y
Configure the Default IP router for the network processors’ Ethernet LAN interface.
Network Processor Ethernet Default IP Router [a.b.c.d]: 197.112.23.1
CHASSIS INFORMATION |
|
Host Name: | LightStream1 |
Chassis Primary (Active) IP Address: | 192.1.1.11 |
Chassis Secondary IP Address: | 192.1.1.12 |
Chassis Subnet Mask: | 255.255.255.0 |
Network Processor Ethernet IP Address: | 197.112.23.12 |
Network Processor Ethernet IP Mask: | 255.255.255.0 |
Network Processor Default IP Router: | 197.112.23.1 |
Chassis configuration contains 2 redundant network processors.
Network processors'
Is the chassis and network processor information correct? (Y/N) [Y] Y
If you confirm that the configuration data you have entered in this step is correct by responding Y to this query, the script continues with the trunk port configuration query below.
Hardware Installation