Cisco Systems 2600 appendix Command Option Country, VC-816

Caller ID on Cisco 2600 and 3600 Series Routers and Cisco MC3810 Multiservice Concentrators

Caller ID Configuration Task List

	Command	Purpose
Step 3
	Router(config-voiceport)# voice confirmation-tone	Enables the two-beep confirmation tone that a
		caller hears when picking up the handset, if
		connection plar or connection plar-opx is
		configured.
Step 4
	Router(config-voiceport)# dial-type{dtmf pulse}	(For FXO ports only) Selects the appropriate dial
		type for out-dialing.
Step 5
	Router(config-voiceport)# signal {loop-start	Selects the appropriate signal type for this
	ground-start}	interface.
Step 6
	Router(config-voiceport)# codec {g729r8 g729ar8	(Cisco MC3810 multiservice concentrator only)
	g726r32 g711alaw g711ulaw}	Configures the voice-port compression mode. The
		g729ar8 value is the default and is recommended.
		Note On Cisco 2600 and 3600 series routers,
		codec configuration is performed on dial
		peers. On all supported routers, codec
		command options may vary depending
		upon the voice card settings.
Step 7
	Router(config-voiceport)# cptone locale	Selects the appropriate voice call progress tone for
		this interface. Caller ID requires this setting. The
		caller ID standard (Bellcore/Telcordia, ETSI,
		ETSI-DTMF) is determined by this command.
		On the Cisco MC3810 multiservice concentrator,
		the default setting for locale is northamerica. On
		Cisco 2600 and 3600 series routers, the default
		setting for locale is us.
		See Table 57 on page 816 for a list of options.
Step 8
	Router(config-voiceport)# ring frequency {25 50}	(Required on Cisco 2600 and 3600 series routers
		FXS ports only) Selects the appropriate ring
		frequency (in hertz) specific to the equipment
		attached to this voice port.
Step 9
	Router(config-voiceport)# caller-id attenuation	(Optional on FXO ports only) Specifies an
	attenuation	attenuation other than the default of 14 dB (minus
		14 dBm), enter a value of from 0 to 64, in decibels.
Step 10
	Router(config-voiceport)# ring number number	(Required on Cisco 2600 and 3600 series routers
		FXO ports only) Specifies the maximum number
		of rings to be detected before answering a call.

The following table lists the options that may be used for the locale variable with the cptone command.

Table 57 cptone Command Entries for the Cisco 2600 and 3600 Series

Command Option	Country	Command Option	Country
ar	Argentina	lu	Luxembourg
au	Australia	my	Malaysia
at	Austria	mx	Mexico
be	Belgium	nl	Netherlands

Cisco IOS Voice, Video, and Fax Configuration Guide

VC-816