Connect the Cisco 800 Series Router to a Hub
Connect the Cisco 800 Series Router to a Hub
Follow these steps to connect the Cisco 800 series router to a hub:
Step 1 Connect the yellow Ethernet cable from the yellow Ethernet port (Cisco 801 and 802 routers) or from the yellow Ethernet port with the number 0 (Cisco 803 and 804 routers) on the back panel of the router to the Ethernet port on the hub.
Figure 3 Connecting a Cisco 800 Series Router to a Hub
HUB |
|
| |
NO HUB | Cisco |
| |
ETHERNET 10 | 803 | ||
BASE T | |||
|
| ||
| CONSOLE | ISDN S/T | |
|
| ||
0 |
| PHONE | |
1 | 2 | ||
| 3 |
| |
Cisco 803 router | 1 | ||
2 | |||
| |||
SPEED | LED | |
100BaseTX | ||
SOLID | ||
10BaseT | ||
BLINK |
1X |
|
|
2X | 10/100 |
|
| 3X | |
|
| 4X |
1 | 2 | 3 | 4 |
5 | 6 | 7 | 8 |
|
| ||
|
|
| 5X |
|
|
| 6X |
|
|
| 7X |
|
|
| 8X |
MDI |
Cisco 1528 Micro Hub 10/100
Step 2 Verify that the HUB/NO HUB switch on the left side of the back panel has been set to the HUB position (in). If the button is out, press it to set it to the in position.
Note The HUB/NO HUB button corresponds to the Ethernet port on Cisco 801 and 802 routers and to Ethernet port 0 on Cisco 803 and 804 routers.
Caution Always connect the yellow cable or Ethernet cable that you supply to the yellow ports on the router. Do not connect the cable to an ISDN S/T or U port or to a Network Termination 1 (NT1) device. Accidently connecting the cable to the wrong port can damage your router.
Connect the Cisco 800 Series Router to a Hub
4 |
| |
|
