4ASSEMBLING YOUR X-TERRA 70
List of Parts
Before assembling your
Coil
Skidplate (fitted to coil)
Lower shaft
Middle shaft
Upper shaft
Armrest
Stand
Control box
Rubber washers (2)
Plastic wing nut
Plastic bolt
Armrest screw
Armrest strap
Velcro tabs (2)
Warranty card
Instruction manual
you’re holding it |
5
Connecting the Coil
Plug the two rubber washers into the holes on either side of the lower shaft yoke.
Slide the yoke into the yoke bracket on top of the coil. Ensure that the spring loaded pin in the lower shaft is underneath the coil shaft, pointing downwards.
Insert the plastic bolt through the yoke and the yoke bracket.
Fasten with the plastic wing nut provided, being careful not to damage the thread of the bolt by
The coil cable is directly wired into the coil and is not removable. Any attempt to disconnect this cable will void your warranty.
Shaft Assembly
Ensure that the twistlocks of the shafts are loosened by rotating them counter- clockwise.
Compress the spring loaded pin in the lower shaft and slide it into the middle shaft until the pin reaches the adjust- ment holes. The pin will spring out and click into place.
Attach the middle shaft to the upper shaft in the same way.
Once shafts are assembled, lock them in position by rotating twistlocks clockwise.
The upper shaft assembly location uses two spring loaded pins to strengthen the joint, one on either side of the shaft.
