10-29
Catalyst 2960 and 2960-S Switch Software Configuration Guide
OL-8603-09
Chapter 10 Configuring IEEE 802.1x Port-Based Authentication
Understanding IEEE 802.1x Port-Based Authentication
• When you manually remove an 802.1x client address from the port se curity table by using the no
switchport port-security mac-address mac-address interface configuration command, you should
re-authenticate the 802.1x client by using the dot1x re-authenticate interface interface-id
privileged EXEC command.
• When an 802.1x client logs off, the port changes to an unauthenticated state, and all dynamic entries
in the secure host table are cleared, including the entry for the client. Normal authentication then
takes place.
• If the port is administratively shut down, the port becomes unauthenticated, and all dynamic entries
are removed from the secure host table.
• Port security and a voice VLAN can be configured simultaneously on an 802.1x port t hat is in either
single-host or multiple-hosts mode. Port security applies to both the voice VLAN identifier (VVID)
and the port VLAN identifier (PVID).
• You can configure the authentication violation or dot1x violation-mode interface configuration
command so that a port shuts down, generates a syslog error, or discards packets from a new device
when it connects to an 802.1x-enabled port or when the maximum number of allowed devices have
been authenticated. For more information see the “Maximum Number of Allowed Devices Per Port”
section on page 10-40 and the command reference for this release.
For more information about enabling port security on your switch, see the “Configuring Port Security”
section on page 23-8.
802.1x Authentication with Wake-on-LAN
Note To use IEEE 802.1x authentication with wake-on-LAN, the switch must be running the LAN base image.
The 802.1x authentication with the wake-on-LAN (WoL) feature allows dormant PCs to be powered
when the switch receives a specific Ethernet frame, known as the magic packet. You can use this feature
in environments where administrators need to connect to systems t hat have been powered down.
When a host that uses WoL is attached through an 802.1x port and the host powers off, the 802.1x port
becomes unauthorized. The port can only receive and send EAPOL packets, and WoL magic packets
cannot reach the host. When the PC is powered off, it is not authorized, and the switch port is not opened.
When the switch uses 802.1x authentication with WoL, the switch forwards traffic to
unauthorized 802.1x ports, including magic packets. While the port is unauthorized, the swit ch
continues to block ingress traffic other than EAPOL packets. The host can r eceive packets but cannot
send packets to other devices in the network.
Note If PortFast is not enabled on the port, the port is forced to the bidirectional state.
When you configure a port as unidirectional by using the authentication control-direction in or dot1x
control-direction in interface configuration command, the port changes to the spanning-tree forwarding
state. The port can send packets to the host but cannot receive packets from the host.
When you configure a port as bidirectional by using the authentication control-direction both or dot1x
control-direction both interface configuration command, the port is access-controlled in both
directions. The port does not receive packets from or send packets to the host.