21-7
Catalyst 2960 and 2960-S Switch Software Configuration Guide
OL-8603-09
Chapter 21 Configuring Dynamic ARP Inspection
Configuring Dynamic ARP Inspection
• The operating rate for the port channel is cumulative across all the physical ports within the channel.
For example, if you configure the port channel with an ARP rate-limit of 400 pps, all the interfaces
combined on the channel receive an aggregate 400 pps. The rate of incoming ARP packets on
EtherChannel ports is equal to the sum of the incoming rate of packets from all the channel
members. Configure the rate limit for EtherChannel ports only after examining the rate of incom ing
ARP packets on the channel-port members .
The rate of incoming packets on a physical port is checked against the port-channel configuration
rather than the physical-ports configuration. The rate-limit configuration on a port channel is
independent of the configuration on its physical ports.
If the EtherChannel receives more ARP packets than the configured rate, the chann el (including all
physical ports) is placed in the error-disabled state.
• Make sure to limit the rate of ARP packets on incoming trunk ports. Configure trunk ports with
higher rates to reflect their aggregation and to handle packets across multiple dynamic ARP
inspection-enabled VLANs. You also can use the ip arp inspection limit none interface
configuration command to make the rate unlimited. A high rate-limit on one VLAN can cause a
denial-of-service attack to other VLANs when the software places the port in the error-disabled
state.
• When you enable dynamic ARP inspection on the switch, policers that were configured to police
ARP traffic are no longer effective. The result is that all ARP traffic is sent to the CPU.
Configuring Dynamic ARP Inspection in DHCP Environments
This procedure shows how to configure dynamic ARP inspection when two switches support this feature.
Host 1 is connected to Switch A, and Host 2 is connected to Switch B as shown in Figure 21-2 on
page 21-3. Both switches are running dynamic ARP inspection on VLAN 1 where the hosts are located.
A DHCP server is connected to Switch A. Both hosts acquire their IP addresses from the same DHCP
server. Therefore, Switch A has the bindings for Host 1 and Host 2, and Switch B has the binding for
Host 2.
Note Dynamic ARP inspection depends on the entries in the DH CP snooping binding database to verify
IP-to-MAC address bindings in incoming ARP requests and ARP responses. Make sure to e nable DHCP
snooping to permit ARP packets that have dynamically assigned IP addresses. For configur ation
information, see Chapter 20, “Configuring DHCP Features and IP Source Guard Features .”
For information on how to configure dynamic ARP inspection when only one sw itch supports the
feature, see the “Configuring ARP ACLs for Non-DHCP Environments” section on page 21-9.