10-32
Catalyst 2960 and 2960-S Switch Software Configuration Guide
OL-8603-09
Chapter 10 Configuring IEEE 802.1x Port-Based Authentication
Understanding IEEE 802.1x Port-Based Authentication
Network Admission Control Layer 2 802.1x Validation
Note To use Network Admission Control, the switch must be running the LAN base image.
The switch supports the Network Admission Control (NAC) Layer 2 802.1x validation, which checks
the antivirus condition or posture of endpoint systems or clients before granting the devices network
access. With NAC Layer 2 802.1x validation, you can do these tasks:
• Download the Session-Timeout RADIUS attribute (Attribute[27]) and the Termination-Action
RADIUS attribute (Attribute[29]) from the authentication server.
• Set the number of seconds between re-authentication attempts as the value of the Session-Timeout
RADIUS attribute (Attribute[27]) and get an access policy against the client from the RADIUS
server.
• Set the action to be taken when the switch tries to re-authenticate the client by using the
Termination-Action RADIUS attribute (Attribute[29]). If the value is the DEFAULT or is not set,
the session ends. If the value is RADIUS-Request, the re-authenti cation process starts.
• Set the list of VLAN number or name or VLAN group name as the value of the Tunnel Group Private
ID (Attribute[81]) and the preference for the VLAN number or name or VLAN group name as the
value of the Tunnel Preference (Attribute[83]). If you do not con figure the Tunnel Preference, the
first Tunnel Group Private ID (Attribute[81]) attribute is picked up from the list.
• View the NAC posture token, which shows the posture of the client, by using the show
authentication or show dot1x privileged EXEC command.
• Configure secondary private VLANs as guest VLANs.
Configuring NAC Layer 2 802.1x validation is similar to configuring 802.1x port-based authentication
except that you must configure a posture token on the RADIUS server. For information about
configuring NAC Layer 2 802.1x validation, see the “Configuring NAC Layer 2 802.1x Validation”
section on page 10-63 and the “Configuring Periodic Re-Authentication” section on page 10-48.
For more information about NAC, see the Network Admission Control Software Configuration Guide.
For more configuration information, see the “Authentication Manager” section on page 10-8.
Flexible Authentication Ordering
You can use flexible authentication ordering to configure the order of methods that a port uses to
authenticate a new host. MAC authentication bypass and 802.1x can b e the primary or secondary
authentication methods, and web authentication can be the fallback method if either or both of those
authentication attempts fail. For more information see the “Configuring Flexible Authentication
Ordering” section on page 10-68.