10-6
Catalyst 2960 Switch SoftwareConfiguration Guide
78-16881-01
Chapter10 Configuring Interface Characteristics
Using Interface Configuration Mode
Step3 Follow each interface command with the interface configuration commands that the interface requires.
The commands that you enter define the protocols and applications that will run on the inter face. The
commands are collected and applied to the interface when you enter another interface command or enter
end to return to privileged EXEC mode.
You can also configure a range of interfaces by using the interface range or interface range macro
global configuration commands. Interfaces configured in a range must be the same type and must be
configured with the same feature options.
Step4 After you configure an interface, verify its status by using the show privileged EXEC commands listed
in the “Monitoring and Maintaining the Interfaces” section on page 10-18.
Enter the show interfaces privileged EXEC command to see a list of all interfaces on or configured for
the switch. A report is provided for each interface that the device supports or for the specified interface.
Configuring a Range of Interfaces
You can use the interface range global configuration command to configure multiple interfaces with the
same configuration parameters. When you enter the interface range configuration mode, all command
parameters that you enter are attributed to all interfaces within that range until you exit this mode.
Beginning in p rivileged EXEC mode, follow th ese steps to configure a range of interfaces with the
sameparameters:
Command Purpose
Step1 configure terminal Enter global configuration mode.
Step2 interface range {port-range | macro
macro_name}
Specify the range of interfaces (VLANs or physical ports) to be
configured, and enter interface range configuration mode.
You can use the interface range command to configure up to five
port ranges or a previously defined macro.
The macro variable is explained in the “Configuring and Using
Interface Range Macros” section on page 10-7.
In a comma-separated port-range, you must enter the interface
type for each entry and enter spaces before and after the comma.
In a hyphen-separated port-range, you do not need to re-enter the
interface type, but you must enter a space before the hyphen.
Step3 Use the normal configuration commands to apply the configuration
parameters to all interfaces in the range. Each command is executed
as it is entered.
Step4 end Return to privileged EXEC mode.
Step5 show interfaces [interface-id] Verify the configuration of the interfaces in the range.
Step6 copy running-config startup-config (Optional) Save your entries in the configuration file.