Cisco Systems 2960 Using the crashinfo File

31-21
Catalyst 2960 Switch SoftwareConfiguration Guide
78-16881-01
Chapter31 Troubleshooting
Using the crashinfo File
Packet 1
Lookup Key-Used Index-Hit A-Data
OutptACL 50_0D020202_0D010101-00_40000014_000A0000 01FFE 03000000
Port Vlan SrcMac DstMac Cos Dscpv
Gi0/2 0005 0001.0001.0001 0009.43A8.0145
Using the crashinfo File
The crashinfo file saves information that helps Cisco technical support representatives to debug
problems that caused the Cisco IOS image to fail (crash). The switch writes the crash information to the
console at the time of the failure, and the file is created the next time you boot the Cisco IOS image after
the failure (instead of while the system is failing).
The information in the file includes the Cisco IOS image name and version that failed, a list of the
processor registers, and a stack trace. You can provide this information to the Cisco technical support
representative by using the show tech-support privileged EXEC command.
All crashinfo files are kept in this directory on the flash file system :
flash:/crashinfo/crashinfo_n where n is a sequence number.
Each new crashinfo file that is created uses a sequence number that is larger than any previously existing
sequence number, so the file with the largest sequence number describes the most recent failure. Version
numbers are used instead of a timestamp because the switches do not include a real-time clock. You
cannot change the name of the file that the system will use when it creates the file. However, after the
file is created, you can use the rename privileged EXEC command to rename it, but the contents of the
renamed file will not be displayed by the show stacks or the show tech-support privileged EXEC
command. You can delete crashinfo files by using the delete privileged EXEC command.
You can display the most recent crashinfo file (that is, the file with the highest sequence number at the
end of its filename) by entering the show stacks or the show tech-support privileged EXEC command.
You also can access the file by using any command that can copy or display files, such as the more or
the copy privileged EXEC command.