(Optional) Display the FastHub 400 Series Hub Manager
If you have the IP address to the hub, you can display the FastHub 400 series Hub Manager from your intranet. You can use the FastHub 400 series Hub Manager to configure and monitor the hub.
1Start Netscape Communicator (4.03 or higher) or Microsoft Internet Explorer (4.01 or higher). Make sure that Java and JavaScript are enabled.
2Enter the IP address of the hub in the URL field if you are using Communicator (the Address field if you are using Internet Explorer).
The FastHub 400 series Hub Manager Home page appears.
Click Apply after making changes on a page. 
Click Revert to discard unapplied changes on a page.
Click Help for procedures and detailed field descriptions.
Click the Mode 
button to change the mode that
the LEDs display for the fixed 10/100 ports.
HOME PORT GROUP IP SNMP CDP SYSTEM |
|
| Click these topics to move from page | ||
| |||||
|
|
| to page. On Netscape Communicator | ||
|
|
| only, when the cursor is above a topic, | ||
|
|
| a | ||
|
|
| on that particular page. | ||
|
|
|
|
| Click a port to display its |
|
|
|
|
| |
|
|
|
|
| settings, status, and statistics. |
|
|
|
|
|
|
Click to display the settings, status, and statistics of an installed 10BaseT/100BaseTX or 100BaseFX switched uplink module.
Shows when another hub is connected to a stacking connector on the hub rear panel.
6
Note: The FastHub 400 10/100 Series Installation and Configuration Guide and the FastHub 400 10/100 series Hub Manager online help provide complete information about the web console and describe how to configure and monitor the hub.
