Cisco Systems 6400 manual Viewing Live Video, Reset Type, Remarks, Initial Setup of the IP Camera”

Chapter 4 Camera Management

Viewing Live Video

You also can also perform these reset operations from the Maintenance Settings window as described in the Cisco Video Surveillance 6000 Series IP Camera Configuration Guide.

Table 4-3	Resetting the IP Camera
Reset Type		Procedure	Remarks
Reboot.		Press and immediately release	This action is equivalent to
		the Reset button.	powering the IP camera down
			and then powering it up. Settings
			that are configured for the IP
			camera are retained.
Factory reset.		Press and hold the button for at	Sets all IP camera options to
		least 15 seconds.	their default values. After you
			perform this procedure, follow
			the steps in the “Performing the
			Initial Setup of the IP Camera”
			section on page 3-1.

Viewing Live Video

After you install and set up the Cisco Video Surveillance IP Camera, you can connect to the IP camera through Internet Explorer and access the Camera Video & Control window to view live video.

The Camera Video & Control window also provides for controlling the video display, configuring preset positions, and controlling certain IP camera functions. Available controls depend on the privilege level of the user.

To view live video, log in to the IP camera, then click View Video in the IP camera Main window menu bar. The Camera Video & Control window appears. This window displays live video from the camera and lets you control a variety of camera and display functions.

The controls that you see in the Camera Video & Control window depend on your IP camera privilege level and the configurations settings for the IP camera. Users with the Administrator privilege can access all controls. Users with the Viewer privilege do not have access to the following controls:

•Video image controls

•Motion detection controls

Table 4-4describes the controls in the Camera Video & Control window.

Table 4-4 Camera Video & Control Window Controls

Control Description

Video controls

Video Codec drop-down list

Choose the codec for video transmission (H.264 or MJPEG).

You can choose H.264 only if the primary video stream (channel 1) is enabled. You can choose MJPEG only if the secondary video stream (channel 2) is enabled.

Cisco Video Surveillance 6400 IP Camera Installation Guide

OL-28494-01 4-5