Chapter 2 Camera Installation
Connecting External Power and I/O Cables
Connecting External Power and I/O Cables
The 6400 IP camera can be powered using Power over Ethernet (PoE), or by using an external power source. If an external power source is used, a power cable must be connected to the General Purpose I/O (GPIO) terminal block on the IP camera. Additionally, external devices that trigger alarms or respond to alarms can be connected to the GPIO terminal block using I/O cables. To avoid moisture damage to the IP camera, the optional external power cable and I/O cables, which are
To connect an external power cable or I/O cables for external devices, perform the following steps:
Procedure
Step 1 Disassemble the components of the waterproof connector into its individual components as shown below.
Screw Nut (A)
Seal (B)
Seals (C)
Housing (D)
Sealing Nut (E)
Step 2 Remove the back cover from the IP camera.
Step 3 Remove the rubber stopper from the bottom of the IP Camera and tightly secure the screw nut (A).
(A)
Cisco Video Surveillance 6400 IP Camera Installation Guide
|
| ||
|
|