Installing the Rack-Mount Brackets on the Chassis
Cisco AS5800 Universal Access Server Hardware Installation Guide2-12
To install the forward rack-mount brackets on the dial shelf for an offset telco rack-mount
configuration, complete the following steps:
Step1 Locate the forward upper and lower threaded holes on the right side of the chassis. (See
Figure2-7, positions a and b.)
Step2 Align one rack-mount bracket with a set of forward-upper threaded holes in the
orientation shown in Figure2-8, position a.
Step3 Thread two M5 x 10-mm Phillips flathead scre ws t hrou gh the bra cket and i nto the side of
the chassis. Tighten the screws using a No. 2 Phillips screwdriver.
Step4 Align the second rack-mount bracket with the forward-lower position threaded holes in
the orientation shown in Figure2-8, position b.
Step5 Fasten the bracket to the chassis using two screws as described in Step3.
Step6 Repeat Step1 through Step 5 to mount the two forward brackets on the left side.
Figure2-8 Positioning the Rack-Mount Brackets for an Offset Telco Rack Installation
Review the remaining sections re gar ding sa fety and s pec ial ra ck-m oun tin g consi de rat ions, and then
proceed to the next chapter, “Installing the CiscoAS5800.”
H11042
Front
Rear