Cisco Systems AVS 3120 installation instructions Attaching a Two-Post Rack Bracket to the AVS

Chapter 3 Installing the AVS 3120

Installing Your AVS 3120

Warning To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions to ensure that the system remains stable. The following guidelines are provided to ensure your safety:

•This unit should be mounted at the bottom of the rack if it is the only unit in the rack.

•When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest component at the bottom of the rack.

•If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in the rack. Statement 1006

This section contains the following procedures:

•Attaching a Two-Post Rack Bracket to the AVS 3120

•Installing the AVS 3120 on a Workbench or Tabletop

Attaching a Two-Post Rack Bracket to the AVS 3120

You may install the AVS 3120 in either a four-post rack or a two-post rack by using the two-post rack brackets included in the accessory kit. Follow these steps:

1.Place the right-hand bracket on the right side of the AVS 3120, as shown in Figure 3-1. Align the bracket with the screw holes in the AVS 3120, and use two round head screws to secure the bracket.

Repeat this step to attach the left-hand bracket to the AVS 3120. Note that the brackets are different.

Cisco AVS 3120 Application Velocity System Hardware Installation Guide

OL-11805-01 3-3