Chapter 2 SIP Protocol Subscriber Features
The Cisco BTS 10200 generates a warning event when a request from a client fails authentication.This can be indicative of a provisioning error, or of an attempt by an unauthorized client to communicate with the Cisco BTS 10200.
The contacts registered for an AOR may be looked up using the status CLI command, as demonstrated by the following example.
CLI>status
AOR ID -> 4692551884@sia-SYS44CA146.ipclab.cisco.com
USER
HOST
PORT
USER TYPE -> USER_PHONE_TYPE
EXPIRES
EXPIRETIME
STATUS -> REGISTERED CONTACT
Reply :Success:
Static Registration
The Cisco BTS 10200 also supports static registration for endpoints that do not support dynamic registration through the SIP REGISTER message. However, dynamic registration takes precedence over static registration.
Note Static registration is not recommended, as it does not allow terminal mobility.
For provisioning information, refer to the Static Contact table section of SIP Adaptor Configuration Parameters, page
Cisco BTS 10200 Softswitch SIP Protocol User Guide
|
| ||
|
|