Cisco Systems MDS 9020 manual Enter yes no is the default to create additional accounts

Chapter 3 Initial Configuration

Initial Setup Routine

Se n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a ck - d o c @ c i s c o . c o m

Step 4 Enter yes (no is the default) to create additional accounts.

Note Only the admin user name can create or modify user accounts.

Create another login account (yes/no) [n]: yes

While configuring your initial setup, you can create an additional user account (in the network-admin role) besides the administrator’s account. See the “Role-Based Authorization” section on page 9-5for information on default roles and permissions.

a.Enter the user login ID.

Enter the user login ID: user_name

b.Enter the user password.

Enter the password for user_name: user-password

Confirm the password for user_name: user-password

c.Enter the user role.

Enter the user role [network-operator]:network_admin

Step 5 Enter yes (no is the default) to configure the read-only or read-write SNMP community string. Configure read-only SNMP community string (yes/no) [n]: yes

a. Enter the SNMP community string.

SNMP community string: snmp_community

Step 6 Enter a name for the switch.

Note The switch name is limited to 32 alphanumeric characters.

Enter the switch name: switch_name

Step 7 Enter yes (yes is the default) to configure out-of-band management.

Continue with Out-of-band (mgmt0) management configuration? [yes/no]: yes

a.Enter the mgmt0 IP address.

Mgmt0 IP address: ip_address

b.Enter the mgmt0 subnet mask.

Mgmt0 IP netmask: subnet_mask

Step 8 Enter yes (yes is the default) to configure the default gateway (recommended).

Configure the default-gateway: (yes/no) [y]: yes

a. Enter the default gateway IP address.

IP address of the default-gateway: default_gateway

Step 9 Enter yes (yes is the default) to enable Telnet service.

Enable the telnet service? (yes/no) [y]: yes

Cisco MDS 9020 Fabric Switch Configuration Guide and Command Reference

3-6 OL-6988-02