Setting up the Hardware | 2 |
| |
Step 1 — Install the Disk Drives |
|
|
|
|
|
Step 1 — Install the Disk Drives
After you remove the NSS from the packaging, you are ready to set up the hardware. If your NSS already has disk drives installed, skip this step.
To install the disk drives into the NSS:
STEP 1 Remove a disk tray from the front of the NSS chassis by pushing in the tab on the latch at the front of the tray then open the latch. (There is no recommended order of which tray to remove first.)
a | b |
NSS2000 2 Bay Gigabit Network Storage System | Power | LAN | SYS | ACT 1 | ERR 1 | ACT 2 | ERR 2 | Linksys by Cisco | 270983 | 270957 |
STEP 2 Position the disk drive into a disk tray.
STEP 3 Using a Phillips screwdriver, either screw in two screws on each side of the disk tray to the disk drive or screw in the four screws on the bottom of the disk tray to the disk drive.
OR
270982
270958
NSS2000 Getting Started Guide | 4 |