Chapter 3 Network Configuration
Configuring Remote Agents (ACS Solution Engine Only)
Step 3 Enter or change AAA server settings, as needed. For information about the configuration options available for the AAA server, see AAA Server Configuration Options, page
Step 4 To save your changes and apply them immediately, click Submit + Apply.
Tip To save your changes and apply them later, choose Submit. When you are ready to implement the changes, choose System Configuration > Service Control. Then, choose Restart.
Note Restarting the service clears the
Deleting AAA Servers
To delete AAA servers:
Step 1 In the navigation bar, click Network Configuration.
The Network Configuration page opens.
Step 2 Do one of the following:
•If you are using NDGs, click the name of the NDG to which the AAA server is assigned. Then, click the AAA server name in the AAA Servers table.
•If you have not enabled NDGs, click the AAA server name in the AAA Servers table.
The AAA Server Setup for X page appears.
Step 3 To delete the AAA server and have the deletion take effect immediately, click Delete + Apply.
Note Restarting the service clears the
A confirmation dialog box appears.
Step 4 Click OK.
ACS performs a restart and the AAA server is deleted.
Configuring Remote Agents (ACS Solution Engine Only)
This section presents information about remote agents and procedures for configuring remote agents in the ACS web interface.
User Guide for Cisco Secure Access Control Server
| ||
|