Cisco Systems PAP2 specs

Phone Adapter with 2 Ports for Voice-over-IP

8. Repeat steps 5-7 until you have entered all four port ranges for the Phone Adapter.

Application	Start and End	Protocol	IP Address	Enable

Internet phone 1	5060 to 5061	UDP	(IP address of	X
			Phone Adapter)

Internet phone 2	53 to 53	UDP	(IP address of	X
			Phone Adapter)

Internet phone 3	69 to 69	UDP	(IP address of	X
			Phone Adapter)

Internet phone 4	10000 to 20000	UDP	(IP address of	X
			Phone Adapter)

9.Check the Enable option for the port services you want to use.

10.When you have completed the configuration, click the Save Settings button.

5.The Power LED does not light up or lights up red. Go through this checklist until your problem is solved:

•Unplug the power adapter from the Phone Adapter. Wait five seconds. Then plug the power adapter into the Phone Adapter again.

•You may be using the wrong power adapter. Make sure the power adapter you are using is the one included with the Phone Adapter.

22	Appendix A: Troubleshooting
	Common Problems and Solutions

Image 28

Cisco Systems PAP2 manual Application Start and End Protocol IP Address Enable

Contents

Phone Adapter Page How to Use this Guide Copyright and Trademarks Phone Adapter with 2 Ports for Voice-over-IP Table of Contents Back Panel Front Panel Welcome IntroductionWhat’s in this Guide? Introduction Getting to Know the Phone Adapter Back Panel Ports Front Panel Phone Adapter’s LEDs are located on the front panelIncoming call has been detected An incoming call has been detected Connecting the Phone Adapter Instructions for Connecting the Phone AdapterOverview Internet Follow the instructions provided by Vonage Connect the Telephone Cable Placement Options Stand OptionRemove the plate from the Phone Adapter’s bottom panel Phone Adapter’s Interactive Voice Response Menu Wall-Mount Option Measurement between Wall-Mount Slots Accessing the Interactive Voice Response Menu Using the Phone Adapter’s Interactive Voice Response MenuUsing the Interactive Voice Response Menu Use this command to enter Response Menu Interactive Voice Response MenuNot press any other keys until you Key or hang up to exit Has been enabled or disabled. If 101 Enter 1 to enableEnter 0 to disable Check Dhcp 100 Address using Static IP address When entering a Decimal pointSubnet Mask Mask using Network mask When entering a Decimal point Address Address using Static gateway IP address When entering a Decimal pointPhone Adapter Manual Reboot 732668 131 Enter the IP Configuring the Settings for Your Internet Phone Service Appendix a Troubleshooting Common Problems and Solutions Appendix a Troubleshooting Application Start and End Protocol IP Address Enable Internet phone 5060 toIP address Phone Adapter Internet phone 53 to IP address Phone Adapter Internet phone 69 to Phone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Application Start and End Protocol IP Address Enable Frequently Asked Questions Ethernet LED does not light up Can I make calls while I’m browsing the Internet? Shared Resources Appendix B Windows HelpNetwork Neighborhood/My Network Places Appendix B Windows Help Appendix C Glossary Appendix C Glossary Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Phone Adapter with 2 Ports for Voice-over-IP Appendix D Specifications Storage Humidity ~90% Non-Condensing Dimensions 98 x 3.98 x H x DMm x 101 mm x 15 mm Appendix E Warranty Information Limited Warranty Appendix E Warranty Information Appendix F Regulatory Information FCC Statement Appendix F Regulatory Information Linksys VonageToll-free from US